RopeCAM for a round and trapezoid thread NC turning

Products:

RopeCAM III

Services:

software for a round and trapezoid thread NC turning

ROPECAM III produces NC-code for any outer or inner diameter rope thread. Programming taper for the rope thread, the ROPECAM III allows declivity for the rope thread profile. ROPECAM III software is possible to be tailor-made for customers own round thread profiles.

You don't need expensive special tools, with RopeCAM you can use standard turning tools.

RopeCAM apply also for a cable barrels thread NC-programming

Video
ROPECAM III produces NC-code for any NC-control.

RopeCAM III new features:

- More advanced thread profile follow up (47% faster).
- Thread roughing by values given by user.
- More advanced thread profile simulation with Zoom and speed control.
- Possibility to measure tool from middle or from corner.
- Possibility to programming direct part to thread top and/or bottom.
- International regional settings
- Trapezoid thread, acme thread NC-turning

- Trapezoid thread, acme thread measurements table

Demo download: ROPECAM III demo download.

RopeCAM III requires:
Operating System: 98, ME, 2000, XP, Vista and 7 (32/64 bit)
Memory 64 MB minimum
Disk Space 1.7 MB